Chapter 33 System
NXC5200 User’s Guide
503
33.11 Language
Click Configuration > System > Language to open this screen. Use this screen
to select a display language for the NXC’s Web Configurator screens.
Figure 236
Configuration > System > Language
Destination
Type the IP address of the station to send your SNMP traps to.
Service
Control
This specifies from which computers you can access which NXC zones.
Add
Click this to create a new entry. Select an entry and click Add to create a
new entry after the selected entry.
Edit
Double-click an entry or select it and click Edit to be able to modify the
entry’s settings.
Remove
To remove an entry, select it and click Remove. The NXC confirms you
want to remove it before doing so. Note that subsequent entries move up
by one when you take this action.
Move
To change an entry’s position in the numbered list, select the method and
click Move to display a field to type a number for where you want to put
it and press [ENTER] to move the rule to the number that you typed.
#
This the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the NXC’s (non-
configurable) default policy. The NXC applies this to traffic that does not
match any other configured rule. It is not an editable rule. To apply other
behavior, configure a rule that traffic will match so the NXC will not have
to use the default policy.
Zone
This is the zone on the NXC the user is allowed or denied to access.
Address
This is the object name of the IP address(es) with which the computer is
allowed or denied to access.
Action
This displays whether the computer with the IP address specified above
can access the NXC zone(s) configured in the Zone field (Accept) or not
(Deny).
Apply
Click Apply to save your changes back to the NXC.
Reset
Click Reset to return the screen to its last-saved settings.
Table 190
Configuration > System > SNMP (continued)
LABEL
DESCRIPTION