Chapter 33 System
NXC5200 User’s Guide
483
33.6.5 Service Control Rules
Click Add or Edit in the Service Control table in a WWW, SSH, Telnet, FTP or
SNMP screen to add a service control rule.
Figure 222
Configuration > System > Service Control Rule > Add/Edit
The following table describes the labels in this screen.
33.6.6 HTTPS Example
If you haven’t changed the default HTTPS port on the NXC, then in your browser
enter “https://NXC IP Address/” as the web site address where “NXC IP Address”
is the IP address or domain name of the NXC you wish to access.
Table 185
Configuration > System > Service Control Rule > Add/Edit
LABEL
DESCRIPTION
Create new
Object
Use this to configure any new settings objects that you need to use in
this screen.
Address
Object
Select ALL to allow or deny any computer to communicate with the NXC
using this service.
Select a predefined address object to just allow or deny the computer
with the IP address that you specified to access the NXC using this
service.
Zone
Select ALL to allow or prevent any NXC zones from being accessed using
this service.
Select a predefined NXC zone on which a incoming service is allowed or
denied.
Action
Select Accept to allow the user to access the NXC from the specified
computers.
Select Deny to block the user’s access to the NXC from the specified
computers.
OK
Click OK to save your customized settings and exit this screen.
Cancel
Click Cancel to exit this screen without saving