Appendix A Log Descriptions
NXC5200 User’s Guide
599
AUX Interface
disconnecting failed.
This AUX interface is
not enabled.
The AUX interface is not enabled and a user tried to use the
disconnect aux command.
Please type phone
number of interface
AUX first then dial
again.
A user tried to dial the AUX interface, but the AUX interface
does not have a phone number set.
Please type phone
number of Interface
AUX first then
disconnect again.
The AUX interface does not have a phone number set and a
user tried to use the disconnect aux command.
Interface %s will
reapply because Device
HA become active
status.
Device-ha became active and is using a PPP base interface,
the PPP interface must reapply, %s is the interface name.
Interface %s will
reapply because Device
HA is not running.
Device-ha was deleted and free PPP base interface, PPP
interface must reapply, %s is the interface name.
Interface %s will stop
connect because Device
HA become standby
status.
When device-ha is stand-by and use PPP base interface, PPP
interface connection will stop,
%s
: interface name.
Create interface %s
has been failed.
When PPP can't running fail,
%s
: interface name.
Base interface %s is
disabled. Interface %s
is disabled now.
When user disable ethernet, vlan or bridge interface and this
interface is base interface of PPP or virtual interface. PPP and
virtual will disable too. 1st %s is interface name, 2nd %s is
interface.
Interface %s has been
changed.
An administrator changed an interface’s configuration.
%s
:
interface name.
Interface %s has been
added.
An administrator added a new interface.
%s
: interface name.
Interface %s is
enabled.
An administrator enabled an interface. %s: interface name.
Interface %s is
disabled.
An administrator disabled an interface. %s: interface name.
%s MTU > (%s MTU - 8),
%s may not work
correctly.
An administrator configured a PPP interface, PPP interface
MTU > (base interface MTU - 8), PPP interface may not run
correctly because PPP packets will be fragmented by base
interface and the peer will not receive correct PPP packets.
1st %s: PPP interface name, 2nd %s: ethernet interface
name.
(%s MTU - 8) < %s MTU,
%s may not work
correctly.
An administrator configured ethernet, vlan or bridge and this
interface is base interface of PPP interface. PPP interface MTU
> (base interface MTU - 8), PPP interface may not run
correctly because PPP packets will be fragmented by base
interface and peer will not receive correct PPP packets.1st
%s: Ethernet interface name, 2nd %s: PPP interface name.
Table 229
Interface Logs (continued)
LOG MESSAGE
DESCRIPTION