Chapter 33 System
NXC5200 User’s Guide
502
33.10.3 Configuring SNMP
To change your NXC’s SNMP settings, click Configuration > System > SNMP
tab. The screen appears as shown. Use this screen to configure your SNMP
settings, including from which zones SNMP can be used to access the NXC. You
can also specify from which IP addresses the access can come.
Figure 235
Configuration > System > SNMP
The following table describes the labels in this screen.
Table 190
Configuration > System > SNMP
LABEL
DESCRIPTION
Enable
Select the check box to allow or disallow the computer with the IP
address that matches the IP address(es) in the Service Control table to
access the NXC using this service.
Server Port
You may change the server port number for a service if needed, however
you must use the same port number in order to use that service for
remote management.
Get
Community
Enter the Get Community, which is the password for the incoming Get
and GetNext requests from the management station. The default is
public and allows all requests.
Set
Community
Enter the Set community, which is the password for incoming Set
requests from the management station. The default is private and allows
all requests.
Trap
Community
Type the trap community, which is the password sent with each trap to
the SNMP manager. The default is public and allows all requests.