DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
137
error_ccm
- Only the fault alarms whose priority is equal to or higher than “Error CCM
Received” are sent.
xcon_ccm
- Only the fault alarms whose priority is equal to or higher than “Cross-connect
CCM Received” are sent.
none
- No fault alarm is sent.
alarm_time
- Specifies the time that a defect must exceed before the fault alarm can be sent.
The unit is centiseconds. The default value is 250.
<centisecond 250-1000>
- Specifies the time that a defect must exceed before the fault alarm
can be sent. The unit is centiseconds. The range is 250 to 1000.
alarm_reset_time
- Specifies the dormant duration time before a defect is triggered before the
fault can be re-alarmed. The unit is centiseconds. The default value is 1000.
<centisecond 250-1000>
- Specifies the dormant duration time before a defect is triggered
before the fault can be re-alarmed. The unit is centiseconds. The range is 250 to 1000.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the parameters of an MEP:
DGS-3710-12C:admin# config cfm mep mepname mep1 state enable ccm enable
Command: config cfm mep mepname mep1 state enable ccm enable
Success.
DGS-3710-12C:admin#
12-7
config cfm ais md
Description
This command is used to configure the parameters of the AIS function on a MEP.
Format
config cfm ais md [<string 22> | md_index <uint 1-4294967295>] ma [<string 22> | ma_index
<uint 1-4294967295>] mepid <int 1-8191> {period [1sec | 1min] | level <int 0-7> | state
[enable | disable]}
Parameters
md
- Specifies the maintenance domain name.
<string 22>
- Specifies the maintenance domain name. The maximum length is 22
characters.
md_index
- Specifies the maintenance domain index.
<uint 1-4294967295>
- Enter the maintenance domain index value here. This value must
be between 1 and 4294967295.
ma
- Specifies the maintenance association name.
<string 22>
- Specifies the maintenance association name. The maximum length is 22
characters.
ma_index
- Specifies the maintenance association index.
<uint 1-4294967295>
- Enter the maintenance association index value here. This value
must be between 1 and 4294967295.