DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
423
Format
show mld_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>]
Parameters
ports
- Specifies a range of ports to be displayed.
<portlist>
- Specifies a range of ports to be displayed.
vlanid
- Specifies a range of VLANs to be displayed.
<vlanid_list>
- Specifies the VLAN ID list.
Restrictions
None.
Example
To display the MLD snooping packet rate limit for ports 1 to 2:
DGS-3710-12C:admin#show mld_snooping rate_limit ports 1-2
Command: show mld_snooping rate_limit ports 1-2
Port Rate Limit
-------- ------------
1
No Limit
2
No Limit
Total Entries: 2
DGS-3710-12C:admin#
42-7
create mld_snooping static_group
Description
This command is used to create an MLD snooping multicast static group. Member ports can be
added to the static group. The static member and the dynamic member port form the member
ports of a group.
The static group will only take effect when MLD snooping is enabled on the VLAN. For those static
member ports, the device needs to emulate the MLD protocol operation to the querier, and forward
the traffic destined to the multicast group to the member ports. For a layer 3 device, the device is
also responsible to route the packet destined for this specific group to static member ports. The
static member port will only affect V2 MLD operation. The Reserved IP multicast addresses
FF0x::/16 must be excluded from the configured group. The VLAN must be created first before a
static group can be created.
Format
create mld_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>] <ipv6addr>
Parameters
vlan
- Specifies the name of the VLAN on which the static group resides.