DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
537
DGS-3710-12C:admin#show bandwidth_control 1-2
Command: show bandwidth_control 1-2
Bandwidth Control Table
Port RX Rate TX Rate Effective RX Effective TX
(Kbit/sec) (Kbit/sec) (Kbit/sec) (Kbit/sec)
---- ---------- ---------- ---------------- ----------------
1 No Limit No Limit No Limit No Limit
2 No Limit No Limit No Limit No Limit
DGS-3710-12C:admin#
53-3
config per_queue bandwidth_control
Description
This command is used to set the bandwidth control for each specific egress queue on specified
ports. The maximum rate limits the bandwidth. When specified, packets transmitted from the
queue will not exceed the specified limit even if extra bandwidth is available. The specification of
maximum rate is effective regardless of whether the queue is operating in strict or Shaped Deficit
Weighted Round Robin (SDWRR) mode.
Format
config per_queue bandwidth_control {ports [<portlist> | all]} <cos_id_list 0-7> {{min_rate
[no_limit | <value 64-1024000>]} max_rate [no_limit | <value 64-1024000>]}
Parameters
ports
- (Optional) Specifies a range of ports to be configured.
<portlist>
- Specifies a range of ports to be configured.
all
- Specifies to set all ports in the system. If no parameter is specified, the system will set all
the ports.
<cos_id_list 0-7>
- Specifies a list of priority queues. The priority queue number ranges from 0 to
7.
min_rate
– (Optional) Specifies the minimum rate that the specified class will be allowed to use
to transmit packets.
no_limit
- Specifies that there is no limit on the egress queue of the specified port bandwidth.
<value 64-1024000>
- Enter the minimum rate value used here. This value must be between
64 and 1024000Kbps.
max_rate
– (Optional) Specifies the maximum rate that the specified class will be allowed to use
to transmit packets.
no_limit
- Specifies that there is no limit on the egress queue of the specified port bandwidth.
<value 64-1024000>
- Enter the maximum rate value used here. This value must be between
64 and 1024000Kbps.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the maximum rate to be 100 on queue 1 for ports 1 to 10: