DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
337
Restrictions
None.
Example
To display all neighbor cache entries for the IP interface “System”:
DGS-3710-12C:admin#show ipv6 neighbor_cache ipif System all
Command: show ipv6 neighbor_cache ipif System all
Neighbor Link Layer Address Interface State
-------------------------- ------------------ ------------ -----
FE80::20B:6AFF:FECF:7EC6 00-0B-6A-CF-7E-C6 System T
Total Entries: 1
State:
(I) means Incomplete state. (R) means Reachable state.
(S) means Stale state. (D) means Delay state.
(P) means Probe state. (T) means Static state.
DGS-3710-12C:admin#
31-4
config ipv6 nd ns ipif
Description
This command is used to configure the NS retransmit time of a specified interface.
Format
config ipv6 nd ns ipif <ipif_name 12> retrans_time <uint 0-4294967295>
Parameters
<ipif_name 12>
- Specifies the name of the interface. The maximum length is 12 characters.
retrans_time
- Specifies the neighbor solicitation’s retransmit timer in milliseconds. It has the
same value as ra retrans_time in the config ipv6 nd ra
command. If one is configured, the
other will change too.
<uint 0-4294967295>
- Specifies the neighbor solicitation’s retransmit timer in milliseconds. It
has the same value as ra retrans_time in the config ipv6 nd ra
command. If one is
configured, the other will change too. Specifies a time between 0 and 4294967295
milliseconds.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the NS retransmit time of a specified interface: