DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
683
Note:
If no VLAN is specified, statistics for all VLANs will be displayed.
Restrictions
None.
Example
To display the VLAN counter statistics for VLAN ID 1 and 2:
DGS-3710-12C:admin#show vlan_counter statistics vlanid 1-2
Command: show vlan_counter statistics vlanid 1-2
VLAN Port Type RX Frames/ RX Bytes Frames Per Sec / Bytes Per Sec
----- ----- ------------ --------------------- ------------------------------
1 - Broadcast(Byte) 1211 103
1 - Multicast(Byte) 111 10
1 1 Broadcast(Byte) 80 7
1 8 Broadcast(Byte) 30 8
CTRL+C
ESC
q
Quit
SPACE
n
Next Page
p
Previous Page
r
Refresh
72-21
enable pvid auto_assign
Description
This command is used to enable the auto-assignment of PVID. If auto-assign PVID is disabled,
PVID can only be changed by PVID configuration (user changes explicitly). The VLAN
configuration will not automatically change PVID. If Auto-assign PVID is enabled, PVID can be
changed by PVID or VLAN configuration. When a user configures a port to VLAN X’s untagged
membership, this port’s PVID will be updated with VLAN X. PVID is updated with the last item of
the VLAN list. When a user removes a port from the untagged membership of the PVID’s VLAN,
the port’s PVID will be assigned with “default VLAN”.
Format
enable pvid auto_assign
Parameters
None. The default setting is enabled.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable the auto-assign PVID: