DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
424
<vlan_name 32>
- Specifies the VLAN name. The maximum length is 32 characters.
vlanid
- Specifies the VLAN ID list.
<vlanid_list>
- Specifies the VLAN ID list.
<ipv6addr>
- Specifies the multicast group IPv6 address (for Layer 3 switch).
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To create an MLD snooping static group on vlan1, group FF1E::1:
DGS-3710-12C:admin#create mld_snooping static_group vlan vlan1 FF1E::1
Command: create mld_snooping static_group vlan vlan1 FF1E::1
Success.
DGS-3710-12C:admin#
42-8
config mld_snooping static_group
Description
This command is used to configure an MLD snooping static group on the switch. When a port is
configured as a static member port, the MLD protocol will not operate on this port. Therefore,
suppose that a port is a dynamic member port learned by MLD. If this port is configured as a static
member later, then the MLD protocol will stop operating on this port. The MLD protocol will resume
once this port is removed from static member ports. The static member port will only affect V1
MLD operation.
Format
config mld_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>] <ipv6addr>
[add | delete] <portlist>
Parameters
vlan
- Specifies the name of the VLAN on which the static group resides.
<vlan_name 32>
- Specifies the VLAN name. The maximum length is 32 characters.
vlanid
- Specifies the ID of the VLAN on which the static group resides.
<vlanid_list>
- Specifies the VLAN ID list.
<ipv6addr>
- Specifies the multicast group IPv6 address (for Layer 3 switch).
add
- Specifies to add the member ports.
delete
- Specifies to delete the member ports.
<portlist>
- Specifies a range of ports to be configured.
Restrictions
Only Administrator and Operator-level users can issue this command.