DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
254
sub_ring
- Specifies the sub-ring configuration information.
raps_vlan
- Specifies the R-APS VLAN.
<vlanid>
- Enter the R-APS VLAN ID used here.
tc_propagation
- Specifies to configure the state of the topology change propagation for the sub-
ring.
state
- Specifies the propagation state of the topology change for the sub-ring.
enable
- Enable the propagation state of the topology change for the sub-ring.
disable
- Disable the propagation state of the topology change for the sub-ring.
add
- Specifies the add a topology change propagation rule.
delete
- Specifies the delete a topology change propagation rule.
sub_ring
- Specifies the sub-ring configuration.
raps_vlan
- Specifies the R-APS VLAN.
<vlanid>
- Enter the R-APS VLAN ID used here.
revertive
- Specifies the revertive mode state.
enable
- Specifies that the revertive mode will be enabled..
disable
- Specifies that the revertive mode will be disabled.
timer
- Configure the ERPS timers for a specific R-APS VLAN.
holdoff_time
- Specifies the holdoff time of the R-APS function.
<value 0-10000>
- Specifies the time between 0 and 10000. The default hold off time is 0
milliseconds.
guard_time
- Specifies the guard time of the R-APS function.
<value 10-2000>
- Specifies the time between 10 and 2000. The default guard time is 500
milliseconds.
wtr_time
- Specifies the WTR time of the R-APS function.
<value 5-12>
- Specifies the time between 5 and 12. The default WTR time is 5 minutes.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To set the R-APS west ring port parameter to 5:
DGS-3710-12C:admin#config erps raps_vlan 4094 ring_port west 5
Command: config erps raps_vlan 4094 ring_port west 5
Success.
DGS-3710-12C:admin#
To set the R-APS east ring port parameter to 7:
DGS-3710-12C:admin#config erps raps_vlan 4094 ring_port east 7
Command: config erps raps_vlan 4094 ring_port east 7
Success.
DGS-3710-12C:admin#
To set the R-APS RPL parameter: