DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
510
DGS-3710-12C:admin#show ethernet_oam ports 1 statistics
Command: show ethernet_oam ports 1 statistics
Port 1
------------------------------------------------------------
Information OAMPDU TX : 0
Information OAMPDU RX : 0
Unique Event Notification OAMPDU TX : 0
Unique Event Notification OAMPDU RX : 0
Duplicate Event Notification OAMPDU TX: 0
Duplicate Event Notification OAMPDU RX: 0
Loopback Control OAMPDU TX : 0
Loopback Control OAMPDU RX : 0
Variable Request OAMPDU TX : 0
Variable Request OAMPDU RX : 0
Variable Response OAMPDU TX : 0
Variable Response OAMPDU RX : 0
Organization Specific OAMPDUs TX : 0
Organization Specific OAMPDUs RX : 0
Unsupported OAMPDU TX : 0
Unsupported OAMPDU RX : 0
Frames Lost Due To OAM : 0
DGS-3710-12C:admin#
48-3
clear ethernet_oam ports
Description
This command is used to clear Ethernet OAM information.
Format
clear ethernet_oam ports [<portlist> | all] [event_log | statistics | remote_loopback
test_result]
Parameters
<portlist>
- Specifies a range of Ethernet OAM ports to be cleared.
all
- Specifies to clear all Ethernet OAM ports.
event_log
- Specifies to clear Ethernet OAM event log information.
statistics
- Specifies to clear Ethernet OAM statistics.
remote_loopback test result
– Specifies to clear the Ethernet OAM remote loopback test result
information.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To clear port 1 OAM statistics: