DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
18
Format
config serial_port {baud_rate [9600 | 19200 | 38400 | 115200] | auto_logout [never |
2_minutes | 5_minutes | 10_minutes | 15_minutes]}(1)
Parameters
baud_rate
-
Specifies the baud rate value. The default baud rate is 115200.
9600
- Specifies a baud rate of 9600.
19200
- Specifies a baud rate of 19200.
38400
- Specifies a baud rate of 38400.
115200
- Specifies a baud rate of 115200.
auto_logout
-
Specifies the timeout value. The default timeout is 10_minutes.
never
- Specifies to never timeout.
2_minutes
-
Specifies when the idle value is over 2 minutes, the device will auto logout.
5_minutes
-
Specifies when the idle value over 5 minutes, the device will auto logout.
10_minutes
- Specifies when the idle value is over 10 minutes, the device will auto logout.
15_minutes
-
Specifies when the idle value is over 15 minutes, the device will auto logout.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the baud rate:
DGS-3710-12C:admin# config serial_port baud_rate 9600
Command: config serial_port baud_rate 9600
Success.
DGS-3710-12C:admin#
2-14
enable clipaging
Description
This command is used to enable pausing of the screen display when show command output
reaches the end of the page. The default setting is enabled.
Format
enable clipaging
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.