DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
665
1 <10 ms. 1345:142::11
2 <10 ms. 2012:14::100
3 <10 ms. 3000::1
Trace complete.
DGS-3710-12C:admin#
Trace the IPv6 routed path between the switch and 1210:100::11 with port 40000:
DGS-3710-12C:admin# traceroute6 1210:100::11 port 40000
Command: traceroute6 1210:100::11 port 40000
1 <10 ms. 3100::25
2 <10 ms. 4130::100
3 <10 ms. 1210:100::11
Trace complete.
DGS-3710-12C:admin#
71-9
config firmware image_id
Description
This command is used to configure or remove the firmware.
Format
config firmware image_id <int 1-2> [delete | boot_up]
Parameters
<int 1-2>
- Enter the firmware image ID value here. This value must be either 1 or 2.
delete
- Specifies to remove the selected firmware.
boot_up
- Specifies to use the selected firmware as the boot-up firmware.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure firmware image ID number 1 to be the boot-up firmware:
DGS-3710-12C:admin#config firmware image_id 1 boot_up
Command: config firmware image_id 1 boot_up
Success.
DGS-3710-12C:admin#