DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
313
Parameters
<ipaddr>
- Specifies the IP address.
mac_address
- Specifies the MAC address.
<macaddr>
- Enter the MAC address here.
ports
- (Optional) Configure the portlist or all ports.
<portlist>
- Specifies a range of ports to be configured.
all
- Specifies to apply to all the ports.
mode
- (Optional) Specifies the IMPB mode used.
arp
- Specifies that the mode will be set as ARP mode. This entry will not be added as an
access entry. If not specified, the mode is ARP mode by default. If the system is in ARP
mode, ARP mode and ACL mode entries will both be active. If the system is in ACL mode,
only the ACL mode entries will be active.
acl
- Specifies that the mode will be set as ACL mode. If ACL mode is enabled, the entry is
added as an access entry.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To create an address binding entry on the Switch:
DGS-3710-12C:admin#create address_binding ip_mac ipaddress 10.1.1.1 mac_address
00-00-00-00-00-11
Command: create address_binding ip_mac ipaddress 10.1.1.1 mac_address 00-00-00-
00-00-11
Success.
DGS-3710-12C:admin#
30-2
create address_binding ip_mac ipv6address
Description
This command is used to create an IP-MAC-Port binding entry using IPv6.
Format
create address_binding ip_mac ipv6address <ipv6addr> mac_address <macaddr> {ports
[<portlist> | all]}
Parameters
<ipv6addr>
- Specify the IPv6 address.
mac_address
- Specify the MAC address.
<macaddr>
- Enter the MAC address here.
ports
- (Optional) Configure the portlist or all ports.
<portlist>
- Specify a range of ports to be configured.
all
- Specify to apply to all the ports.