DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
5
reboot Used to restart the switch.
reconfig Used to re-telnet to member.
CTRL+C
ESC
q
Quit
SPACE
n
Next Page
ENTER
Next Entry
a
All
The top-level commands consist of commands such as
show
or
config
. Most of these commands
require one or more parameters to narrow the top-level command. This is equivalent to
show
what?
or
config
what? Where the what? is the next parameter.
For example, entering the
show
command with no additional parameters, the CLI will then display
all of the possible next parameters.
DGS-3710-12C:admin#show
Command: show
Next possible completions:
Option Description
------------------------------------------------------------------------------
802.1p
802.1x
access_profile Used to display current access list table.
account Used to display user accounts.
accounting Used to show accounting state
acct_client Used to show RADIUS accounting client.
address_binding
arp_spoofing_prevention Show ARP spoofing prevention status.
arpentry Used to display the ARP table.
attack_log Show attack log messages.
auth_client Used to show RADIUS authentication client.
auth_diagnostics Used to show authentication diagnostics.
auth_session_statistics Used to show session statistics.
auth_statistics Used to show authentication statistics.
authen
authen_enable Used to show a user-defined or default or all method
lists for promoting user's privilege to Admin level
authen_login Used to show a user-defined or default or all method
lists of authentication methods for user login
CTRL+C
ESC
q
Quit
SPACE
n
Next Page
ENTER
Next Entry
a
All
In the above example, all of the possible next parameters for the
show
command are displayed. At
the next command prompt, the up arrow was used to re-enter the
show
command, followed by the
account
parameter. The CLI then displays the user accounts configured on the Switch.
1-3
Command Syntax Symbols
Syntax
Description
angle brackets < >
Encloses a variable or value. Users must specify the variable or value.
For example, in the syntax
create ipif <ipif_name 12> {<network_address>} <vlan_name 32>