DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
355
Chapter 35
Link Aggregation
Commands
create link_aggregation group_id
<value 1-6> {type [lacp | static]}
delete link_aggregation group_id
<value 1-6>
config link_aggregation group_id
<value 1-6> {master_port <port> | ports <portlist> | state
[enable | disable]}(1)
config link_aggregation algorithm
[mac_source | mac_destination | mac_source_dest |
ip_source | ip_destination | ip_source_dest]
show link_aggregation
{group_id <value 1-6> | algorithm}
config lacp_port
<portlist> {mode [active | passive] | lacp_timeout [short | long]}
show lacp_port
{<portlist>}
35-1
create link_aggregation group_id
Description
This command is used to create a link aggregation group.
Format
create link_aggregation group_id <value 1-6> {type [lacp | static]}
Parameters
<value 1-6>
- Specifies the group ID. The group number identifies each of the groups. The switch
allows up to 6 link aggregation groups to be configured.
type
- (Optional) Specifies the group type belongs to static or LACP. If type is not specified, the
default is the static type.
lacp
- Specifies the group type as LACP.
static
- Specifies the group type as static.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To create a link aggregation group:
DGS-3710-12C:admin#create link_aggregation group_id 1 type lacp
Command: create link_aggregation group_id 1 type lacp
Success
DGS-3710-12C:admin#