DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
550
disable
- Specifies to disable DSCP trust.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable DSCP trust on ports 1 to 8:
DGS-3710-12C:admin#config dscp trust 1-8 state enable
Command: config dscp trust 1-8 state enable
Success.
DGS-3710-12C:admin#
53-19
show dscp trust
Description
This command is used to display the DSCP trusted state for the specified ports on the switch.
Format
show dscp trust {<portlist>}
Parameters
<portlist>
- (Optional) Specifies a range of ports to display.
Note:
If no parameter is specified, the system will display the DSCP trusted state for
all ports on the switch.
Restrictions
None.
Example
To display DSCP trust status on ports 1 to 5:
DGS-3710-12C:admin#show dscp trust 1-5
Command: show dscp trust 1-5
Port DSCP-Trust
----- ----------
1 Disabled
2 Disabled
3 Disabled
4 Enabled