DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
482
Chapter 47
Network Monitoring
Commands
show packet ports
<portlist>
show error ports
<portlist>
show utilization
[ports {[frame | bytes]} | cpu]
show utilization dram
show utilization flash
show historical_counter
[packet | error] [ports <portlist>] [15_minute {slot <index 1-96>} | 1_day
{slot <index 1-2>}]
show historical_utilization
[cpu | memory] [15_minute {slot <index 1-96>} | 1_day {slot <index 1-
2>}]
clear historical_counters ports
[<portlist> | all]
clear counters
{ports <portlist>}
clear log
show log
{[index <value_list> | severity {module <module_list>} {emergency | alert | critical | error |
warning | notice | informational | debug | <level_list 0-7>} | module <module_list>]}
show log_save_timing
show log_software_module
config log_save_timing
[time_interval <min 1-65535> | on_demand | log_trigger]
enable syslog
disable syslog
show syslog
config syslog host
[<index> | all] {severity [emergency | alert | critical | error | warning | notice |
informational | debug | <level 0-7>] | facility [local0 | local1 | local2 | local3 | local4 | local5 |
local6 | local7] | udp_port <udp_port_number> | ipaddress[<ipaddr> | <ipv6addr>] | state
[enable | disable]} (1)
create syslog host
<index 1-4> ipaddress [<ipaddr> | <ipv6addr>] {severity [emergency | alert |
critical | error | warning | notice | informational | debug | <level 0-7>] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> | state [enable |
disable]}
delete syslog host
[<index 1-4> | all]
show syslog host
{<index 1-4>}
show attack_log
{index <value_list>}
clear attack_log
47-1
show packet ports
Description
This command is used to display statistics about the packets sent and received by the switch.
Format
show packet ports <portlist>
Parameters
<portlist>
- Specifies a port or range of ports to be displayed.