DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
453
DGS-3710-12C:admin#show greeting_message
Command: show greeting_message
==============================================================================
DGS-3710-12C Fast Ethernet Switch
Command Line Interface
Firmware: Build 1.00.029
Copyright(C) 2012 D-Link Corporation. All rights reserved.
==============================================================================
DGS-3710-12C:admin#
44-3
config command_prompt
Description
This command is used to modify the command prompt. The current command prompt consists of
four parts: “product name” + “:” + ”user level” + ”#” (e.g. “
DGS-3710-12C:admin#
”
). This
command is used to modify the first part (1. “product name”) with a string consisting of a maximum
of 16 characters, or to be replaced with the users’ login user name.
Format
config command_prompt [<string 16> | username | default]
Parameters
<string 16>
- Specifies the new command prompt string of no more than 16 characters.
username
- Specifies the command to set the login username as the command prompt.
default
- Specifies the command to return the command prompt to its original factory default
value.
Restrictions
1.
When users issue the “reset” command, the current command prompt will remain in tact.
Issuing the “reset system” will return the command prompt to its original factory default value.
2.
Only Administrator and Operator-level users can issue this command.
Example
To edit the command prompt:
DGS-3710-12C:admin#config command_prompt HQ0001
Command: config command_prompt HQ0001
Success.
HQ0001:admin#