DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
37
Format
config out_band_ipif {ipaddress <network_address> | state [enable | disable] | gateway
<ipaddr>} (1)
Parameters
ipaddress
- Specifies the IP address of the interface. The parameter must include the mask.
<network_address>
- Specifies the IP address of the interface. The parameter must include
the mask.
state
– Specifies the interface status.
enable
- Specifies to enable the interface.
disable
- Specifies to disable the interface.
gateway
- Specifies the gateway IP address of the out-of-band management network.
<ipaddr>
- Specifies the gateway IP address.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To disable the out-of-band management state:
DGS-3710-12C:admin#config out_band_ipif state disable
Command: config out_band_ipif state disable
Success.
DGS-3710-12C:admin#
3-8
show out_band_ipif
Description
This command is used to display the current configurations of special out-of-band management
interfaces.
Format
show out_band_ipif
Parameters
None.
Restrictions
None.
Example
To display the configuration of out-of-band management interfaces: