DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
464
parameter is for STP and RSTP version. MSTP version uses per-port hellotime parameter.
<value 1-2>
- Specifies the time interval for sending Configuration BPDUs by the Root Bridge.
This parameter is for STP and RSTP version. MSTP version uses per-port hellotime
parameter. The default value is 2 seconds.
forwarddelay
- Specifies the maximum delay time for one BPDU to be transmitted by a bridge
and received from another bridge.
<value 4-30>
- Specifies the maximum delay time for one BPDU to be transmitted by a bridge
and received from another bridge. The default value is 15.
txholdcount
- Specifies to restrict the numbers of BPDU transmitted in a time interval (per Hello
Time).
<value 1-10>
- Specifies to restrict the numbers of BPDU transmitted in a time interval (per
Hello Time).
fbpdu
- To decide if the Bridge will flood STP BPDU when STP functionality is disabled.
enable
- Specifies to enable FBPDU.
disable
- Specifies to disable FBPDU.
nni_bpdu_addr
- Specifies to determine the BPDU protocol address for STP in service provide
site. It can use an 802.1d STP address or an 802.1ad service provider STP address.
dot1d
- Specifies to use an 802.1d STP address.
dot1ad
- Specifies to use an 802.1ad service provider STP address.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure STP:
DGS-3710-12C:admin# config stp maxage 25
Command: config stp maxage 25
Success.
DGS-3710-12C:admin#
45-14
config stp ports
Description
This command is used to configure all the parameters of ports, except for Internal Path Cost and
Port Priority.
Format
config stp ports <portlist> {externalCost [auto | <value 1-200000000> ] | hellotime <value 1-
2> | migrate [yes | no] | edge [true | false | auto] | p2p [true | false | auto] | state [enable |
disable] | restricted_role [true | false] | restricted_tcn [true | false] | fbpdu [enable | disable ]}
(1)
Parameters
<portlist>
- Specifies a range of ports.
externalCost
- Specifies the path cost between the MST regions from the transmitting Bridge to
the CIST Root Bridge. It is only used at CIST level.
auto
- Specifies to automatically choose the path cost.