DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
463
45-12
config stp priority
Description
This command is used to configure the instances’s priority and can be used to select the root
bridge.
Format
config stp priority <value 0-61440> instance_id <value 0-15>
Parameters
<value 0-61440>
- Specifies the bridge priority value, which must be divisible by 4096. The
default value is 32768.
instance_id
- Specifies the identifier value, which is used to distinguish different STP instances.
<value 0-15>
- Specifies the identifier value, which is used to distinguish different STP
instances.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the instance 0’s priority to 61440:
DGS-3710-12C:admin#config stp priority 61440 instance_id 0
Command: config stp priority 61440 instance_id 0
Success.
DGS-3710-12C:admin#
45-13
config stp
Description
This command is used to configure the bridge parameter global settings.
Format
config stp {maxage <value 6-40> | maxhops <value 6-40> | hellotime <value 1-2> |
forwarddelay <value 4-30> | txholdcount <value 1-10> | fbpdu [enable | disable] |
nni_bpdu_addr [dot1d | dot1ad]} (1)
Parameters
maxage
- Specifies to determine if a BPDU is valid.
<value 6-40>
- Specifies to determine if a BPDU is valid. The default value is 20.
maxhops
- Specifies to restrict the forwarded times of one BPDU.
<value 6-40>
- Specifies to restrict the forwarded times of one BPDU. The default value is 20.
hellotime
- Specifies the time interval for sending Configuration BPDUs by the Root Bridge. This