DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
661
DGS-3710-12C:admin#show config current_config
Command: show config current_config
#-----------------------------------------------------------------------------
# DGS-3710-12C Fast Ethernet Switch
# Configuration
#
# Firmware: Build 1.00.029
# Copyright(C) 2012 D-Link Corporation. All rights reserved.
#-----------------------------------------------------------------------------
# ENVIRONMENT
config temperature threshold high 79
config temperature threshold low 11
config temperature trap state disable
config temperature log state enable
# BASIC
# ACCOUNT LIST
# ACCOUNT END
# PASSWORD ENCRYPTION
disable password_encryption
CTRL+C
ESC
q
Quit
SPACE
n
Next Page
ENTER
Next Entry
a
All
71-5
ping
Description
This command is used to send Internet Control Message Protocol (ICMP) echo messages to a
remote IP address. The remote IP address will then “echo” or return the message. This is used to
confirm connectivity between the switch and the remote device.
Format
ping <ipaddr> {times <value 1-255>} {timeout <sec 1-99>} {size <value 1-6000>}
Parameters
<ipaddr>
-
Specifies the IP address of the host.
times
– (Optional) Specifies the number of individual ICMP echo messages to be sent.
<value 1-255>
- Specifies the number of individual ICMP echo messages to be sent. A value
of 0 will send an infinite ICMP echo messages. The maximum value is 255. The default is 0
timeout
–
(Optional)
Specifies the time-out period while waiting for a response from the remote
device. A value of 1 to 99 seconds can be specified. The default is 1 second.
<sec 1-99>
- Specifies the time-out period while waiting for a response from the remote
device. A value of 1 to 99 seconds can be specified. The default is 1 second.
size
- (Optional) Specifies the size.
<value 1-6000>
- Enter the size. A value of 1 to 6000 can be specified. The default is 100.