DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
248
Example
To enable unidirectional link detection on port 1:
DGS-3710-12C:admin# config duld ports 1 state enable
Commands: config duld ports 1 state enable
Success
DGS-3710-12C:admin#
23-2
show duld ports
Description
This command is used to show unidirectional link detection information.
Format
show duld ports {<portlist>}
Parameters
ports
- (Optional) Specify a range of ports to be display.
<portlist>
- Enter the list of ports to be displayed here.
Note:
If no ports are specified, all the ports will be displayed
Restrictions
None.
Example
To display ports 1-4 unidirectional link detection information:
DGS-3710-12C:admin#show duld ports 1-4
Command: show duld ports 1-4
Port Admin State Oper Status Mode Link Status Discovery Time(Sec)
----- ----------- ----------- -------- -------------- -------------------
1 Enabled Disabled Normal Unknown 5
2 Enabled Disabled Normal Unknown 5
3 Disabled Disabled Normal Unknown 5
4 Enabled Disabled Normal Unknown 5
DGS-3710-12C:admin#