DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
422
Example
To delete all the groups learned by data-driven:
DGS-3710-12C:admin#clear mld_snooping data_driven_group all
Command: clear mld_snooping data_driven_group all
Success.
DGS-3710-12C:admin#
42-5
config mld_snooping rate_limit
Description
This command is used to configure the upper limit per second for ingress MLD control packets.
Format
config mld_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>] [<value 1-1000> |
no_limit]
Parameters
ports
- Specifies a range of ports to be configured.
<portlist>
- Specifies a range of ports to be configured.
vlanid
- Specifies a range of VLANs to be configured.
<vlanid_list>
- Specifies the VLAN ID list.
<value 1-1000>
- Specifies the rate limit of MLD control packet that the switch can process on a
specific port/VLAN. The rate is specified in packet per second. The packet that exceeds the
limited rate will be dropped.
no_limit
- The default setting is no limit.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the MLD snooping packet rate limit on port 1 for 100:
DGS-3710-12C:admin#config mld_snooping rate_limit ports 1 100
Command: config mld_snooping rate_limit ports 1 100
Success.
DGS-3710-12C:admin#
42-6
show mld_snooping rate_limit
Description
This command is used to display the MLD snooping rate limit setting.