DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
536
<value 64-1024000>
- Specifies an integer value from 64 to 1024000 to set a maximum limit
in Kbits/sec. The specified bandwidth limit may be equaled but not exceeded. This exact
logical limit or token value is hardware determined. Actual rate = (inputted rate/ 64) * 64.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure port bandwidth:
DGS-3710-12C:admin#config bandwidth_control 1-10 tx_rate 1024
Command: config bandwidth_control 1-10 tx_rate 1024
Success.
DGS-3710-12C:admin#
53-2
show bandwidth_control
Description
This command is used to display the port bandwidth configurations. The bandwidth can also be
assigned by the RADIUS server through the authentication process. If the RADIUS server has
assigned the bandwidth, then the RADIUS-assigned bandwidth will be the effective bandwidth.
Format
show bandwidth_control {<portlist>}
Parameters
<portlist>
- (Optional) Specifies a range of ports to be displayed.
Note:
If no parameter is specified, the system will display all port bandwidth
configurations.
Restrictions
None.
Example
To display the port bandwidth control table for ports 1 to 2: