DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
674
DGS-3710-12C:admin#show port_vlan 1-3
Command: show port_vlan 1-3
Port PVID GVRP Ingress Checking Acceptable Frame Type
------- ---- -------- ---------------- ----------------------------
1 1 Disabled Enabled All Frames
2 1 Disabled Enabled All Frames
3 1 Disabled Enabled All Frames
Total Entries : 3
DGS-3710-12C:admin#
72-9
config gvrp
Description
This command is used to set the GVRP timer’s value.
Format
config gvrp [timer [join | leave | leaveall] <value 100-100000> | nni_bpdu_addr [dot1d |
dot1ad]]
Parameters
timer
– Specifies GVRP timer.
join
- Specifies the Join time will be set. The default value is 200 milliseconds.
leave
- Specifies the Leave time will be set. The default value is 600 milliseconds.
leaveall
- Specifies the LeaveAll time. The default value is 10000 milliseconds.
<value 100-100000>
- Specifies the time value. The value range is 100 to 100000 milliseconds.
In addition, the Leave time should greater than 2 Join times and the LeaveAll time should
greater than Leave time.
nni_bpdu_addr
- Determine the BPDU protocol address for GVRP in service provide site. It can
use 802.1d GVRP address, or 802.1ad service provider GVRP address.
dot1d
- Specifies a 802.1d GVRP address.
dot1ad
- Specifies a 802.1ad service provider GVRP address.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To set the Join time to 200 milliseconds:
DGS-3710-12C:admin#config gvrp timer join 200
Command: config gvrp timer join 200
Success.
DGS-3710-12C:admin#