DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
157
Restrictions
None.
Example
To display CFM remote MEP information:
DGS-3710-12C:admin#show cfm remote_mep mepname mep1 remote_mepid 2
Command: show cfm remote_mep mepname mep1 remote_mepid 2
Remote MEPID : 2
MAC Address : 00-11-22-33-44-02
Status : OK
RDI : Yes
Port State : Blocked
Interface Name : Down
Last CCM Serial Number : 1000
Send Chassis ID : 00-11-22-33-44-00
Sender Management Address: SNMP-UDP-IPv4 10.90.90.90:161
Detect Time : 2008-01-01
DGS-3710-12C:admin#
12-30
config cfm ccm_fwd
Description
This command is used to configure the CCM PDUs forwarding mode.
Format
config cfm ccm_fwd [software | hardware]
Parameters
software
- Specifies to forward by using the software.
hardware
- Specifies to forward by using the hardware.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the CCM PDUs forwarding mode to hardware:
DES-3810-28:admin# config cfm ccm_fwd hardware
Command: config cfm ccm_fwd hardware
Success.
DES-3810-28:admin#