DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
241
For the optic port, when a particular threshold was configured by user, it will be shown in this
command with a tag indicating that it is a threshold that user configured, else it would be the
threshold read from the optic module that is being inserted.
Format
show ddm ports {<portlist>}
Parameters
ports
- Specifies a range of ports to be displayed.
<portlist>
- (Optional) Enter the range of ports to be displayed here.
Restrictions
None.
Example
To show port 2’s operating parameters:
DGS-3710-12C:admin#show ddm ports 2
Command: show ddm ports 2
Port : 2
----------------------------------------
DDM State : Enabled
Shutdown : None
Module Type : None
++ : high alarm, + : high warn, - : low warn, -- : low alarm.
Current High Alarm High Warn Low Warn Low Alarm
Threshold Threshold Threshold Threshold
--------------- --------------- ----------- ----------- ----------- -----------
Temperature(C) - 84.96(A) 70.00(A) 2.25(A) -10.00(A)
Voltage(V) - - - - -
Tx Bias(mA) - - - - -
Tx Power(dbm) - - - - -
Rx Power(dbm) - - - - -
A means that the threshold is administratively configured.
DGS-3710-12C:admin#