DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
227
19-22
show dhcp pool manual_binding
Description
This command is used to display the configured manual binding entries.
Format
show dhcp pool manual_binding {<pool_name 12>}
Parameters
<pool_name 12>
- (Optional) Specifies the DHCP pool name.
Restrictions
None.
Example
To display the configured manual binding entries:
DGS-3710-12C:admin#show dhcp pool manual_binding
Command: show dhcp pool manual_binding
Pool Name IP Address Hardware Address Type
------------ ------------- ------------------ --------
p1 192.168.0.1 00-80-C8-08-13-88 Ethernet
p1 192.168.0.2 00-80-C8-08-13-99 Ethernet
Total Entries : 2
DGS-3710-12C:admin#
19-23
enable dhcp_server
Description
This command is used to enable the DHCP server function.
If DHCP relay is enabled, DHCP server cannot be enabled. The opposite is also true. For Layer 2
switches, if DHCP client is enabled on the only interface, then DHCP server cannot be enabled.
For layer 3 switches, if DHCP client is enabled on an interface, the DHCP server can be enabled.
However, DHCP server will not service the packet that is received from this interface.
Format
enable dhcp_server
Parameters
None.