DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
28
Restrictions
None.
Example
To display the configuration of the current terminal width:
DGS-3710-12C:admin#show terminal width
Command: show terminal width
Global terminal width : 80
Current terminal width : 80
DGS-3710-12C:admin#
2-28
config external_alarm channel
Description
This command is used to configure the external alarm message for a channel. The alarm port is
located outside of the switch. It is monitored via pre-defined connection channels, with each
channel representing a specific alarm event. This command allows the user to define the alarm
event associated with each channel.
Format
config external_alarm channel <value 1-4> message <sentence 1-128>
Parameters
channel
- Specifies which channel number to use.
<value 1-4>
- Enter the channel number used here. This value must be between 1 and 4.
message
- Specifies the alarm messages that will be displayed on the console, log and trap.
<sentence 1-128>
- Enter the alarm message used here. This message can be up to 128
characters long.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the external alarm channel used to ‘1’, with a user-defined message:
DGS-3710-12C:admin# config external_alarm channel 1 message External Alarm: UPS
is exhausted!
Command: config external_alarm channel 1 message External Alarm: UPS is
exhausted!
Success.
DGS-3710-12C:admin#