DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
149
Example
To start a CFM loopback test:
DGS-3710-12C:admin# cfm loopback 00-01-02-03-04-05 mepname mep1
Command: cfm loopback 00-01-02-03-04-05 mepname mep1
Request timed out.
Request timed out.
Reply from MPID 52: bytes=xxx time=xxxms
Request timed out.
CFM loopback statistics for 00-01-02-03-04-05:
Packets: Sent=4, Received=1, Lost=3(75% loss)
DGS-3710-12C:admin#
12-21
cfm linktrace
Description
This command is used to issue a CFM link track message.
Format
cfm linktrace [<macaddr> | remote_mepid <int 1-8191>] [mepname <string 32> | mepid <int
1-8191> md [<string 22> | md_index <uint 1-4294967295>] ma [<string 22> | ma_index <uint
1-4294967295>]] {ttl <int 2-255> | pdu_priority <int 0-7>}
Parameters
<macaddr>
- Specifies the destination MAC address.
remote_mepid
- Specifies the remote MEP ID used
.
<int 1-8191>
- Enter the remote MEP ID used here. This value must be between 1 and 8191.
mepname
- Specifies the MEP name.
<string 32>
- Specifies the MEP name. The maximum length is 32 characters.
mepid
- (Optional) Specifies the MEPID.
<int 1-8191>
- Specifies the MEP MEPID between 1 and 8191.
md
- (Optional) Specifies the maintenance domain name.
<string 22>
- Specifies the maintenance domain name. The maximum length is 22
characters.
md_index
– Specifies the MD index value used.
<uint 1-4294967295>
- Enter the MD index value used here. This value must be between
1 and 4294967295.
ma
- (Optional) Specifies the maintenance association name.
<string 22>
- Specifies the maintenance association name. The maximum length is 22
characters.
ma_index
– Specifies the MA index value used.
<uint 1-4294967295>
- Enter the MA index value used here. This value must be between
1 and 4294967295.
ttl
- (Optional) Specifies the link trace message TTL value. The default value is 64.
<int 2-255>
- Specifies the link trace message TTL value. Enter a value between 2 and 255.
pdu_priority
- (Optional) Specifies the 802.1p priority to be set in the transmitted LBMs. If not
specified, it uses the same priority as CCMs and LTMs sent by the MA.
<int 0-7>
- Specifies the 802.1p priority to be set in the transmitted LBMs. If not specified, it
uses the same priority as CCMs and LTMs sent by the MA. Enter a value between 0 and 7.