DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
656
src_file
- Specifies the path name and file name of the TFTP server. It can be a relative path
name or an absolute path name. If path name is not specified, it refers to the TFTP server
path. The maximum length is 64 characters.
<path_filename 64>
- Specifies the path name and file name of the TFTP server. It can be a
relative path name or an absolute path name. If path name is not specified, it refers to the
TFTP server path. The maximum length is 64 characters.
<config_id 1-2>
- (Optional) Enter the configuration ID value used here. This value can either be
1 or 2.
increment
- (Optional) If increment is specified, then the existing configuration will not be cleared
before applying of the new configuration. If it is not specified, then the existing configuration
will be cleared before applying of the new configuration.
Restrictions
Only Administrator-level users can issue this command.
Example
To download runtime configuration firmware from a TFTP server:
DGS-3710-12C:admin#download cfg_fromTFTP 10.90.90.90 src_file config.cfg
Command: download cfg_fromTFTP 10.90.90.90 src_file config.cfg
Connecting to server................... Done.
Download configuration................. Done.
DGS-3710-12C:admin#
71-2
upload
Description
This command is used to upload a new firmware or a switch configuration file.
Format
upload [cfg_toTFTP [<ipaddr> | <ipv6addr>] dest_file <path_filename 64> {<config_id 1-2>}
{[include | exclude | begin] <filter_string 80> {<filter_string 80> {<filter_string 80>}} {[include
| exclude | begin] <filter_string 80> {<filter_string 80> {<filter_string 80>}} {[include |
exclude | begin] <filter_string 80> {<filter_string 80> {<filter_string 80>}}}}} | log_toTFTP
[<ipaddr> | <ipv6addr>] dest_file <path_filename 64> | attack_log_toTFTP [<ipaddr> |
<ipv6addr>] dest_file <path_filename 64>]
Parameters
cfg_toTFTP
- Used to upload a configuration file from a device to a TFTP server.
<ipaddr>
-
Specifies the IP address of the TFTP server.
<ipv6addr>
-
Specifies the IPv6 address of the TFTP server.
dest_file
-
Specifies the path name on the TFTP server. It can be a relative path name or an
absolute path name
<path_filename 64>
- Specifies the location of the switch configuration file on the TFTP
server. This file will be replaced by the uploaded file from the switch. The maximum length
is 64 characters.
<config_id 1-2>
- (Optional) Enter the configuration ID used here. This ID must be either 1 or 2.