DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
316
mac_address
- Specifies the MAC address.
<macaddr>
- Enter the MAC address here.
ports
- (Optional) Configure the portlist to apply, if ports are not configured, then it will apply to all
ports.
<portlist>
- Specifies the list of ports to apply.
all
- Specifies to apply to all the ports.
mode
- (Optional) Specifies the IMPB mode used.
arp
- Specifies that the mode will be set as ARP mode. This entry will not be added as an
access entry. If not specified, the mode is ARP mode by default. If the system is in ARP
mode, ARP mode and ACL mode entries will both be active. If the system is in ACL mode,
only the ACL mode entries will be active.
acl
- Specifies that the mode will be set as ACL mode. If ACL mode is enabled, the entry is
added as an access entry.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure an address binding entry:
DGS-3710-12C:admin#config address_binding ip_mac ipaddress 10.1.1.1 mac_address
00-00-00-00-00-11
Command: config address_binding ip_mac ipaddress 10.1.1.1 mac_address 00-00-00-
00-00-11
Success.
DGS-3710-12C:admin#
30-5
config address_binding ip_mac ipv6address
Description
This command is used to update an address binding entry using IPv6.
Format
config address_binding ip_mac ipv6address <ipv6addr> mac_address <macaddr> {ports
[<portlist> | all]}
Parameters
ipv6address
- Specifies the IPv6 address used.
<ipv6addr>
- Enter the IPv6 address used here.
mac_address
- Specify the MAC address.
<macaddr>
- Enter the MAC address here.
ports
- (Optional) Configure the portlist to apply, if ports are not configured, then it will apply to all
ports.
<portlist>
- Specify the list of ports to apply.
all
- Specify to apply to all the ports.