DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
360
short
- Specifies that the LACP timeout value will be set to 3 seconds when no LACPDU
packet was received and that the LACPDU periodical transmission interval will be set to 1
second.
long
- Specifies that the LACP timeout value will be set to 90 seconds when no LACPDU
packet was received and that the LACPDU periodical transmission interval will be set to 30
seconds.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure port LACP mode for ports 1 to 3:
DGS-3710-12C:admin#config lacp_port 1-3 mode active
Command: config lacp_port 1-3 mode active
Success.
DGS-3710-12C:admin#
35-7
show lacp_port
Description
This command is used to display per-port LACP mode.
Format
show lacp_port {<portlist>}
Parameters
<portlist>
- (Optional) Specifies a range of ports to be displayed.
Note:
If no parameter is specified, the system will display current LACP and status for
all ports.
Restrictions
None.
Example
To display the current port LACP mode for ports 1 to 3 on the switch: