DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
1
Chapter 1
Using Command Line
Interface
The Switch can be managed through the Switch’s serial port, Telnet, SNMP or the Web-based
management agent. The Command Line Interface (CLI) can be used to configure and manage the
Switch via the serial port or Telnet interfaces.
This manual provides a reference for all of the commands contained in the CLI. Every command
will be introduced in terms of purpose, format, description, parameters, and examples.
Configuration and management of the Switch via the Web-based management agent are
discussed in the User Manual. For detailed information on installing hardware please also refer to
the User Manual.
1-1
Accessing the Switch via the Serial Port
The Switch’s serial port’s default settings are as follows:
•
115200 baud
•
no parity
•
8 data bits
•
1 stop bit
A computer running a terminal emulation program capable of emulating a VT-100 terminal and a
serial port configured as above is then connected to the Switch’s serial port via an RS-232 DB-9
cable. With the serial port properly connected to a management computer, the following message
will be displayed, “
Press any key to login…
”. After pressing any key on the keyboard, the
following screen should be visible.
DGS-3710-12C Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 1.00.029
Copyright(C) 2012 D-Link Corporation. All rights reserved.
UserName:admin
PassWord:****
DGS-3710-12C:admin#
Enter the UserName and Password here and press the
Enter
key, after each entry, to display the
CLI input cursor
−
DGS-3710-12C:admin#
.
This is the command line where all commands are
input.
Note:
By default, there is one administrator account already created. The username
for this default account is
admin
and the password is
1234
.