DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
239
To configure the port 2’s transmit power threshold:
DGS-3710-12C:admin#config ddm ports 2 tx_power_threshold high_alarm 0.625
low_alarm 0.006 high_warning 0.55 low_warning 0.008
Command: config ddm ports 2 tx_power_threshold high_alarm 0.625 low_alarm 0.006
high_warning 0.55 low_warning 0.008
Success.
DGS-3710-12C:admin#
To configure the port 2’s receive power threshold:
DGS-3710-12C:admin# config ddm ports 2 rx_power_threshold high_alarm 4.55
low_alarm 0.01 high_warning 3.5 low_warning 0.03
Command: config ddm ports 2 rx_power_threshold high_alarm 4.55 low_alarm 0.01
high_warning 3.5 low_warning 0.03
Success.
DGS-3710-12C:admin#
To configure port 6’s actions associate with the alarm:
DGS-3710-12C:admin# config ddm ports 6 state enable shutdown alarm
Command: config ddm ports 6 state enable shutdown alarm
Success.
DGS-3710-12C:admin#
21-3
config ddm power_unit
Description
The command is used to configure the DDM RX/TX power unit.
Format
config ddm power_unit [mw | dbm]
Parameters
power_unit
– Specifies the DDM RX/TX power unit used.
mw
– Specifies that the DDM RX/TX power unit used, is milliwatts.
dbm
– Specifies that the DDM RX/TX power unit used, is millidb.
Restrictions
Only Administrator and Operator-level users can issue this command.