DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
16
is enable.
enable
- Enable either the trap or log state for a warning temperature event.
disable
-
Disable either the trap or log state for a warning temperature event.
Restrictions
None.
Example
To enable the warning temperature trap state:
DGS-3710-12C:admin#config temperature trap state enable
Command: config temperature trap state enable
Success.
DGS-3710-12C:admin#
To enable the warning temperature log state:
DGS-3710-12C:admin#config temperature log state enable
Command: config temperature log state enable
Success.
DGS-3710-12C:admin#
2-11
config temperature threshold
Description
This command is used to configure the warning temperature high threshold or low threshold. When
temperature is above the high threshold or below the low threshold, SW will send alarm traps or
keep the logs.
Format
config temperature threshold {high <temperature> | low <temperature>}(1)
Parameters
high
-
Specifies the high threshold value. The high threshold must bigger than the low threshold.
<temperature>
- Specifies the high threshold value.
low
-
Specifies the low threshold value.
<temperature>
- Specifies the low threshold value.
Restrictions
None.