DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
663
DGS-3710-12C:admin#ping6 3FFE:2::D04D:7878:66D:E5BC times 10 size 6000 timeout
10
Command: ping6 3FFE:2::D04D:7878:66D:E5BC times 10 size 6000 timeout 10
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000 time<10 ms
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000 time<10 ms
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000 time<10 ms
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000 time<10 ms
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000 time<10 ms
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000 time<10 ms
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000 time<10 ms
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000 time<10 ms
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000 time<10 ms
Reply from 3FFE:2::D04D:7878:66D:E5BC, bytes=6000 time<10 ms
Ping Statistics for 3FFE:2::D04D:7878:66D:E5BC
Packets: Sent =10, Received =10, Lost =0
DGS-3710-12C:admin#
71-7
traceroute
Description
This command is used to trace a route between the switch and a given host on the network.
Format
traceroute <ipaddr> {ttl <value 1-60> | port <value 30000-64900> | timeout <sec 1-65535> |
probe <value 1-9>}
Parameters
<ipaddr>
- Specifies the IP address of the destination end station.
ttl
- (Optional) Specifies the time to live value of the trace route request.
<value 1-60>
- Specifies the time to live value of the trace route request. This is the maximum
number of routers that a trace route packet can pass while seeking the network path
between two devices. The range for the TTL is 1 to 60 hops. The default value is 30.
port
- (Optional) Specifies the port number.
<value 30000-649000>
- Specifies the port number. The value range is from 30000 to 64900.
The default is 33435.
timeout
-
(Optional) Specifies the timeout period while waiting for a response from the remote
device.
<sec 1-65535>
- Specifies the timeout period while waiting for a response from the remote
device. A value of 1 to 65535 seconds can be specified. The default is 5 seconds.
probe
– (Optional)
Specifies the number of probes.
<value 1-9>
- Specifies the number of probes. The range is from 1 to 9. If unspecified, the
default value is 1.
Restrictions
Only Administrator and Operator-level users can issue this command.