DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
375
all
- Specifies to set all ports in the system.
state
- Enable or disable the SNMP trap notification of topology change detected state.
enable
- Enable the SNMP trap notification of topology change detected.
disable
- Disable the SNMP trap notification of topology change detected. The default
notification state is disabled.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable topology change notification on ports 1 to 2:
DGS-3710-12C:admin#config lldp_med notification topo_change ports 1-2 state
enable
Command: config lldp_med notification topo_change ports 1-2 state enable
Success.
DGS-3710-12C:admin#
36-12
config lldp_med ports
Description
This command is used to enable or disable transmitting LLDP-MED TLVs. It effectively disables
LLDP-MED on a per-port basis by disabling transmission of TLV capabilities. In this case, the
remote table’s objects in the LLDP-MED MIB corresponding to the respective port will not be
populated.
Format
config lldp_med ports [<portlist> | all] med_transmit_capabilities [all | {capabilities |
network_policy | inventory} (1) ] state [enable | disable]
Parameters
<portlist>
- Specifies a range of ports to be configured.
all
- Specifies to set all ports in the system.
med_transit_capabilities
- Select to send the LLDP-MED TLV capabilities specified.
all
- Select to send capabilities, network policy, and inventory.
capabilities
– (Optional) Specifies that the LLDP agent should transmit “LLDP-MED capabilities
TLV.” If a user wants to transmit LLDP-MED PDU, this TLV type should be enabled.
Otherwise, this port cannot transmit LLDP-MED PDU.
network_policy
- (Optional) Specifies that the LLDP agent should transmit “LLDP-MED network
policy TLV.”
inventory
- (Optional) Specifies that the LLDP agent should transmit “LLDP-MED inventory TLV.”
state
- Enable or disable the transmitting of LLDP-MED TLVs.
enable
- Enable the transmitting of LLDP-MED TLVs.
disable
- Disable the transmitting of LLDP-MED TLVs.
Restrictions
Only Administrator and Operator-level users can issue this command.