DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
33
<ipv6networkaddr>
- The IPv6 address and subnet prefix of the IPV6 address to be
created.
state
- Enable or disable the IPv6 state of the IP interface.
enable
- Enable the IPv6 state of the IP interface.
disable
- Disable the IPv6 state of the IP interface.
ipv4 state
- The state of the IPv4 interface.
enable
- Enable the IPv4 state of the IP interface.
disable
- Disable the IPv4 state of the IP interface.
dhcpv6_client
- Specifies the DHCPv6 client state of the interface.
enable
- Specifies that the DHCPv6 client state of the interface will be enabled.
disable
- Specifies that the DHCPv6 client state of the interface will be disabled.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the System IP interface:
DGS-3710-12C:admin#config ipif System vlan v1
Command: config ipif System vlan v1
Success.
DGS-3710-12C:admin#
3-2
create ipif
Description
This command is used to create an L3 interface. This interface can be configured with IPv4 or IPv6
addresses. Currently, it has a restriction: an interface can have only one IPv4 address defined. But
it can have multiple IPv6 addresses defined. Configuration of IPv6 addresses must be done
through the command
config ipif
.
Format
create ipif <ipif_name 12> {<network_address>} <vlan_name 32> {state [enable | disable]}
Parameters
<ipif_name 12>
- Specifies the name of the interface.
<network_address>
- (Optional) Specifies a host address and length of network mask.
<vlan_name 32>
- Specifies the name of the VLAN corresponding to the IP interface. The
maximum length is 32 characters.
state
- The state of the IP interface.
enable
- Enable the state setting.
disable
- Disable the state setting.
Restrictions
Only Administrator and Operator-level users can issue this command.