DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
513
<min 3-30>
- Enter the countdown value used here. This value must be between 3 and 30
minutes.
time_interval
- The sampling interval of received packet counts. The possible value will be 5 to
600 seconds. This parameter is meaningless for dropping packets is selected as action.
<sec 5-600>
- Enter the time interval value used here. This value must be between 5 and 600
seconds.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure traffic control and state:
DGS-3710-12C:admin#config traffic control 1-10 broadcast enable action shutdown
threshold 640 time_interval 10
Command: config traffic control 1-10 broadcast enable action shutdown threshold
640 time_interval 10
Success.
DGS-3710-12C:admin#
49-2
config traffic control auto_recover_time
Description
This command is used to configure the traffic auto recover time that allowed for a port to recover
from shutdown forever status. The time allowed for auto recovery from shutdown for a port. The
default value is 0, so no auto recovery is possible; the port remains in shutdown forever mode.
This requires manual entry of the CLI command “
config ports [ <portlist> | all ] state enable
" to
return the port to a forwarding state. The default value is 0, which means disable auto recover
mode, shutdown forever.
Format
config traffic control auto_recover_time [<min 0> | <min 1-65535>]
Parameters
<min 0>
- Enter the automatic recovery time used here. This value will specifies the time to be 0
otherwise known as 'no recovery mode'.
<min 1-65535>
- Enter the automatic recovery time used here. This value must be between 1
and 65535 minutes.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the auto recover time to 5 minutes: