DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
506
disable
- Specifies to disable event notification.
critical_link_event
–Specifies critical link event.
dying_gasp
- An unrecoverable local failure condition has occurred.
critical_event
- An unspecified critical event has occurred.
notify_state
- Specifies the event notification status. The default state is enable.
enable
- Specifies to enable event notification.
disable
- Specifies to disable event notification.
remote_loopback
- Specifies remote loop.
start
- If start is specified, it will request the peer to change to the remote loopback mode.
stop
- If stop is specified, it will request the peer to change to the normal operation mode.
test
- Specifies to enable or disable the test feature.
enable
- Specifies that the test feature will be enabled.
disable
- Specifies that the test feature will be disabled.
timeout
- Specifies the timeout value used here.
<sec 1-65535>
- Enter the timeout value used here. This value must be between 1 and
65535 seconds.
received_remote_loopback
- Specifies receive remote loop-back.
process
- Specifies to process the received Ethernet OAM remote loopback command.
ignore
- Specifies to ignore the received Ethernet OAM remote loopback command. The
default method is”ignore”.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure Ethernet OAM on ports 1 to 2 in active mode:
DGS-3710-12C:admin#config ethernet_oam ports 1-2 mode active
Command: config ethernet_oam ports 1-2 mode active
Success.
DGS-3710-12C:admin#
To enable Ethernet OAM on port 1:
DGS-3710-12C:admin#config ethernet_oam ports 1 state enable
Command: config ethernet_oam ports 1 state enable
Success.
DGS-3710-12C:admin#
To configure the error symbol threshold to 2 and period to 1000ms for port 1:
DGS-3710-12C:admin#config ethernet_oam ports 1 link_monitor error_symbol
threshold 2 window 1000 notify_state enable
Command: config ethernet_oam ports 1 link_monitor error_symbol threshold 2
window 1000 notify_state enable
Success.
DGS-3710-12C:admin#