DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
270
Restrictions
Only Administrator-level users can issue this command.
Example
To display the DHCP server/client filter list created on the switch:
DGS-3710-12C:admin#show filter dhcp_server
Command: show filter dhcp_server
Enabled Ports:
Trap & Log State: Disabled
Illegal Server Log Suppress Duration:5 minutes
Filter DHCP Server/Client Table
Server IP Address Client MAC Address Port
----------------- ------------------ --------------------
Total Entries: 0
DGS-3710-12C:admin#
26-3
config filter extensive_netbios
Description
This command is used to configure the switch to deny NetBIOS packets over 802.3 frames on the
network. Enabling the filterNetBIOS packets over 802.3 frames will create one access profile and
one access rule per port automatically. Filter commands in this file will share the same access
profile.
Format
config filter extensive_netbios [<portlist> | all] state [enable | disable]
Parameters
<portlist>
- Specifies the port or range of ports to configure.
all
- Specifies to configure all ports.
state
- Specifies the status of the filter to block the NetBIOS packets over 802.3 frames.
enable
- Enable the filter to block the NetBIOS packets over 802.3 frames.
disable
- Disable the filter to block the NetBIOS packets over 802.3 frames.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the extensive NetBIOS filter state on ports 1 to 10: