DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
478
Example
To enable SNMP linkchange traps for ports 1 to 4:
DGS-3710-12C:admin#config snmp linkchange_traps ports 1-4 enable
Command: config snmp linkchange_traps ports 1-4 enable
Success.
DGS-3710-12C:admin#
46-17
show snmp traps
Description
This command is used to display the SNMP trap state.
Format
show snmp traps {linkchange_traps {ports <portlist>}}
Parameters
linkchange_traps
- (Optional) Specifies to display the status of linkchange traps.
ports
-
(Optional)
Specifies a port or port range.
<portlist>
-
Specifies a port or port range.
Restrictions
None.
Example
To display SNMP traps:
DGS-3710-12C:admin#show snmp traps
Command: show snmp traps
SNMP Traps : Enabled
Authenticate Trap : Enabled
Linkchange Traps : Enabled
Coldstart Traps : Enabled
Warmstart Traps : Enabled
DGS-3710-12C:admin#
To display SNMP linkchange traps: