DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
65
radiusAcctClient ==>
radiusAcctClientInvalidServerAddresses 0
radiusAcctClientIdentifier D-Link
radiusAuthServerEntry ==>
radiusAccServerIndex : 3
radiusAccServerAddress 0.0.0.0
radiusAccClientServerPortNumber X
radiusAccClientRoundTripTime 0
radiusAccClientRequests 0
radiusAccClientRetransmissions 0
radiusAccClientResponses 0
radiusAccClientMalformedResponses 0
radiusAccClientBadAuthenticators 0
radiusAccClientPendingRequests 0
radiusAccClientTimeouts 0
radiusAccClientUnknownTypes 0
radiusAccClientPacketsDropped 0
DGS-3710-12C:admin#
4-30
config accounting service
Description
This command is used to configure the state of the specified RADIUS accounting service.
Format
config accounting service [network | shell | system] state [enable | disable]
Parameters
network
- Specifies the accounting service for 802.1X port access control. By default, the service
is disabled.
shell
- Specifies the accounting service for shell events. When a user logins or logouts of the
switch (via the console, Telnet, or SSH) and when timeout occurs, accounting information will
be collected and sent to the RADIUS server. By default, the service is disabled.
system
- Specifies the accounting service for system events: reset and reboot. By default, the
service is disabled.
state
- Specifies the state of the accounting service.
enable
- Enable the specified accounting service.
disable
- Disable the specified accounting service.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the state of the RADIUS accounting service shell to enable: