DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
335
Chapter 31
IPv6 NDP
Commands
create ipv6 neighbor_cache ipif
<ipif_name 12> <ipv6addr> <macaddr>
delete ipv6 neighbor_cache ipif
[<ipif_name 12> | all] [<ipv6addr> | static | dynamic | all]
show ipv6 neighbor_cache ipif
[<ipif_name 12> | all] [ipv6address <ipv6addr> | static | dynamic |
all]
config ipv6 nd ns ipif
<ipif_name 12> retrans_time <uint 0-4294967295>
show ipv6 nd
{ipif <ipif_name 12>}
31-1
create ipv6 neighbor_cache ipif
Description
This command is used to add a static neighbor on an IPv6 interface.
Format
create ipv6 neighbor_cache ipif <ipif_name 12> <ipv6addr> <macaddr>
Parameters
<ipif_name 12>
- Specifies the interface’s name.
<ipv6addr>
- Specifies the IPv6 address of the neighbor.
<macaddr>
- Specifies the MAC address of the neighbor.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To add a static entry into the NDP table:
DGS-3710-12C:admin#create ipv6 neighbor_cache ipif System 3ffc::1
00:01:02:03:04:05
Command: create ipv6 neighbor_cache ipif System 3FFC::1 00-01-02-03-04-05
Success.
DGS-3710-12C:admin#
31-2
delete ipv6 neighbor_cache ipif
Description
This command is used to delete a neighbor cache entry or static neighbor cache entries from the
address cache or all address cache entries on this IP interface. Both static and dynamic entries
can be deleted.