DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
640
Chapter 66
Synchronous
Ethernet Commands
config sync_ethernet state
[enable | disable] {source_port <port>}
show sync_ethernet
66-1
config sync_ethernet state
Description
This command is used to configure the port Synchronous Ethernet state and source port.
Format
config sync_ethernet state [enable | disable] {source_port <port>}
Parameters
state
- Specifies the Synchronous Ethernet feature's state.
enable
- Specifies that the Synchronous Ethernet feature's state will be enabled.
disable
- Specifies that the Synchronous Ethernet feature's state will be disabled.
source_port
- (Optional) Specifies the port used for synchronizing with partners.
<port>
- Enter teh source port used here.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable the port Synchronous Ethernet state on port 9:
DGS-3710-12C:admin#config sync_ethernet state enable source_port 9
Command: config sync_ethernet state enable source_port 9
Success.
DGS-3710-12C:admin#
66-2
show sync_ethernet
Description
This command is used to display the Synchronous Ethernet infomation.
Format
show sync_ethernet