DGS-3710 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
173
Chapter 16
Debug Software
Command List
debug address_binding
[event | dhcp | all]
no debug address_binding
debug error_log
[dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
debug buffer
[utilization | dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
[module <module_list> | all] [buffer | console]
debug show error_reboot state
debug stp clear counter
{ports [<portlist> | all]}
debug stp config ports
[<portlist> | all] [event | bpdu | state_machine | all] state [disable | brief |
detail]
debug stp show counter
{ports [<portlist> | all]}
debug stp show flag
{ports <portlist>}
debug stp show information
debug stp state
[disable | enable]
debug dhcpv6_client state enable
debug dhcpv6_client state disable
debug dhcpv6_client output
{all | receiving | sending} state [enable | disable]
debug dhcpv6_relay state enable
debug dhcpv6_relay state disable
debug dhcpv6_relay hop_count state
[enable | disable]
{all | receiving | sending} state [enable | disable]
debug show status
{module <module_list>}
16-1
debug address_binding
Description
This command is used to start the IMPB debug when the IMPB module receives an ARP/IP packet
or a DHCP packet.
Format
debug address_binding [event | dhcp | all]
Parameters
event
- To print out the debug messages when IMPB module receives ARP/IP packets.
dhcp
- To print out the debug messages when the IMPB module receives the DHCP packets.
all
- Print out all debug messages.
Restrictions
Only Administrator level users can issue this command.